Pressure Sensors

The bottom half of the Module Seal consists of a 1/2 inch thick rubber membrane at the top of the mounting post. This provides a hermetic seal for the Isolator Ring keeping the instrument oil in and the air out. The top half of the Module Seal is the "Stinger Fitting" a brass or stainless steel fitting with a needle projecting out of the bottom. Replacing the gauge without compromising the integrity of the vacuum and without removing the isolator ring from the process pipe - is simple:

  1. Close the Block Valve.
  2. Unscrew the Lock Ring.
  3. Pull the gauge and stinger fitting out as a complete unit.
  4. Plug the new gauge and stinger assembly into the Module Seal.
  5. Re-tighten the Lock Ring.
  6. Open the Block Valve.

Smart Box 3 Smart Box 3
Pressure Sensor Syringe Kit Pressure Sensor Syringe Kit
Pressure Sensor PSW Pressure Sensor PSW
Pressure Sensor PSS Pressure Sensor PSS
Pressure Sensor PSR Pressure Sensor PSR
Pressure Sensor PSQ Pressure Sensor PSQ
Pressure Sensor Calibrating Machine Pressure Sensor Calibrating Machine
Diapheagm Seal Model K Diapheagm Seal Model K

CONTACT BACK